Cel-Fi PRO 3G/4G Repeater

  • Carrier
  • Donor Antenna

1,769.00 1,769.00 1769.0 AUD

1,510.00

This combination does not exist.

Add to Cart

Cel-Fi PRO Repeater has been tested, authorised and approved by the ACMA to use on all Australian Mobile Networks.

For the Cel-Fi PRO to operate effectively the surrounding area must not be saturated with 5GHz WiFi. You may need to switch your WiFi router to use 2.4GHz if any issues occur.


The Cel-Fi PRO for Optus Smart Repeater acts as a signal booster, making it an ideal product to boost and distribute a 3G/4G mobile signal within your home or office. With this mobile smart repeater supporting voice and mobile internet, dropped calls and slow internet are a thing of the past.


SUITABLE FOR

  • Home or Small Office Environment
  • Those who have a minimum of 1 bar of coverage within their home or office – this is usually next to a window. It is unlikely you will need an antenna unless your coverage is intermittent.
  • Areas that are not saturated with 5GHz WiFi. The PRO uses a 5GHz wireless link between the two boxes. There are limited 5GHz channels and if your home/office has utilised most of the channels then the wireless link between the boxes may drop, causing your phone calls to drop. Switching your WiFi network to 2.4GHz or rebooting your router to use a different channel can assist with this. For saturated 5GHz areas, we recommend you use the Cel-Fi GO.

Choose your External Antenna:

Blackhawk LPDA 698-4000 12/14dBi
Cel-Fi PRO Optus with LPDA

An LPDA antenna needs to be pointed towards the direction of where the signal is coming from and pole mounted. It covers all the cellular ranges so is suitable for all carriers.

Omni High Gain 698-2700 6dBi
Cel-Fi PRO Optus with Omni

An omni-directional antenna does not need to point towards the direction of where the signal is coming from and will receive a signal from 360 degrees. It can be roof, gutter or wall-mounted. Not recommended for use in remote/ rural areas.

Wideband LPDA 698-2700 8/9dBi
Cel-Fi PRO Optus with Wideband LPDA

This ultra-light LPDA antenna needs to be pointed towards the direction of where the signal is coming from and pole mounted. Much smaller in size than the Blackhawk LPDA and has slightly less dB gain.

Blackhawk Yagi 698-890 14dBi

For those who know the mobile operator is using the low 700-900MHz frequency bands in their area and only want to use these bands. A Yagi antenna needs to be pointed towards the direction of where the signal is coming from and pole mounted.

SUPPORTED NETWORKS

Nextivity’s third generation Cel-Fi PRO is a cost-effective and intelligent indoor coverage solution for the 3G and 4G networks operating on the 3G 900/2100Mhz and 4G 1800/2600 bands. It is designed to dramatically improve indoor voice quality and increase data speeds for 3G or 4G consumers.

The Cel-fi PRO differs greatly from the standard indoor repeater due to its ability to not interfere with the mobile network or other users. Often referred to as a Smart Repeater, the Cel-Fi has the ability to provide maximum coverage, be network friendly and can be easily installed by the end-user.

OPTUS VERSION (Optus, TPG, Amaysim, Dodo, iiNet, plus more)

TELSTRA VERSION (TelstraAldi MobileBoost MobileWoolworths Connect + other MVNO’s)

CEL-FI SETUP

Cel-Fi Layout

 
 
 
This is a preview of the recently viewed products by the user.
Once the user has seen at least one product this snippet will be visible.

Recently viewed Products

Suggested alternatives: